Price Paint (Pty) Ltd Disclaimer
Price Paint is a retailer of the products it distributes. Price Paint does not warrant the product that is manufactured on its behalf. All warranties are at the full discretion of the manufacturer/s. Price Paint manufacturers limit warranties to the replacement of product only and not labour. Price Paint does not provide guarantees, the life expectancy of Price Paint products are based on the coverage as per the technical data sheet. Lower micron applications will severely affect weathering and fading. The application process on the can serves as a guide only. The explanations above are generic, it is imperative that you read the technical data sheet (TDS) thoroughly prior to utilization of product. Intended for qualified professionals only. Whilst every effort is made to make certain that the technical information provided is accurate and correct, errors beyond our control may occur
IMPORTANT IMFORMATION
➢ Please note that a third coat may be required, one drop coat followed by two coats.
➢ In the case of applying a sheen product a base coat is highly recommended for good coverage.
➢ When coating over raw cement, ceiling and dry walling first apply Price Paint Transparent sealer followed by Price Paint flexible plaster primer, if this process is not followed, this could result in poor adhesion and possible peeling or flaking.
➢ Do not overcoat over Price Paint Crack Filler or any type of Poly Filler /Filler, without first sealing with Price Paint Transparent sealer, failure to do so, will result in dull /light patching over repaired areas.
➢ Please check colour prior to use, patch test is highly recommended. Colour variances will occur between batches. Always ensure edge to edge painting to prevent this from happening. Measure correctly to ensure enough product is purchased from one batch.
➢ Price Paint must be utilized as a complete system, do not mix Price Paint products with any other brands.
➢ Do not attempt washing of painted surface prior to the full drying time of 30 days, as streaking will occur.
➢ A mixture of water and a light detergent should be used when washing coated areas after painting, no harsh chemicals should be used.
➢ If the product is not over coated with a 50% overlap with roller/brush this will create an uneven continuity of the pigment (colour).
➢ It is very important to continually mix the product during the application process, failure to do so, may cause patching and colour variance.
➢ In the case of rubber-based products it is advisable to store in a cool area. Occasionally stir product during storage time. It is preferable to paint shortly after purchase.
➢ Please ensure that you wash all Price Paint painting equipment thoroughly with warm soapy water and allow to dry prior to use.
➢ ➢ All surfaces / substrates need to be thoroughly cleaned and prepped prior to use. Walls must be cleaned prior to painting by means of sugar soap.
➢ Water base products may not be applied at temperatures of 5°c or lower, this will result in freezing and potential cracking and peeling.
➢ In cold conditions, below 15°c, allow up to 24hours drying time between coats, sooner than this will severely impact coverage.
➢ Please ensure that the paint dries and cures between each subsequent coat. This may take up to 24hours or longer dependent on the weather conditions.
➢ Life expectancy of Price Paint products is based on the coverage as per Technical Data Sheets. Lower micron applications will severely affect weathering and fading.
➢ Do not thin Price Paint products.
➢ Do not paint Acrylic/PVA over a solvent based surface without scuffing the area and using a Universal undercoat. (Tip: Dip the cotton ball into Acetone and rub on the area of surface to be painted, if the paint transfers onto the cotton ball then it is a water-based product).
➢ Do not use Thinners/ Turps in Price Paint water-based product Most paints and protective coating products are available in reusable 1litre, 5 litre and 20 Litre plastic containers.
About Price paint
Price paint coatings was developed with the aim not just to compete but to dominate in terms of price, engineering, and overall performance. Initially operating as a factory direct retailer, price paint is now expanding into stockists and distribution markets. While there are over 320 paint manufacturers, price paint has positioned itself to compete among the major players. We believe in not only competing but excelling in service offerings. Instead of overtrading in areas, price paint limits the number of stockists and distributors per region, allowing for reasonable markups and ensuring customer satisfaction.
Mission
Price paint is dedicated to delivering effective products, efficient & respectful public service with integrity and accountability using both proven and innovation methods.
Vision
To ensure price paint products is the number one choice to utilise on all projects. For price paint to remain a company of high standards and ethics to work at and to develop new technology as a team.
Value
We strive to always be a responsible, ethical, accountable and a respectful company. We promote honesty and integrity in all that we do. We encourage innovation to meet challenges. We foster an environment of collaboration.
How to calculate paint needed
To simply calculate the amount of paint needed on a wall for a two coat application; 70 – 80 sqm per 20L bucket (This would vary according to the surface texture)